Skip to main content
U.S. flag

This is an original und secure website

3-Point Skin Fold Bodyfat Calculator

Here you can convert the units of measure.

3-Point Skin Fold Bodyfat

years
kg
mm
mm
mm
mm
mm

The following calculator gives you an estimate of your % bodyfat and lean body mass based on your weight, age and thickness measurements of 3 skin folds. It is based on the Jackson-Pollock 3-point method and is reasonably accurate for most people. This method, however, as almost all popular skin fold methods, tends to underestimate body fat levels in very lean bodybuilders.

Note: This statistics calculator is presented for your oTo perform each measurement: Using the tips of your thumb and forefinger pinch the skin in the area to be measured. Pull the skin away from the muscle, being sure to ‘get’ all the subcutaneous fat underneath the skin but don’t include the underlying muscle. Measure the thickness of this fold of fat and skin, in millimeters, with either a ruler (metric) or skin fold calipers. If you do have calipers, the jaws should be placed close to where the fingertips have the skin pinched so an accurate reading can be obtained (about 1 cm (1/4 in) away from the fingers). Release the caliper’s handles and wait 2 seconds before taking the reading. Take a reading of that same site a few more times (release the fold and get a new ‘pinch’ for each measurement) and take the average – each reading should be within 1 or 2 mm of each other. If you don’t have calipers you’ll have to make do with a ruler.

The procedure differs between genders. Males take measurements at the pectoral, abdominal and thigh regions and females take measurements at the triceps, suprailiac and thigh regions. The locations for both sexes are illustrated below.

What are skinfold measurements?

While there are many ways to determine body fat percentage, skinfold measurement is one of the most common. It is also one of the most convenient methods that anyone can perform at home.

This method uses a caliper to measure skinfold thickness (subcutaneous fat tissue) in common fat-storing areas such as the abdomen, chest and thighs (for men) or triceps, thighs and hamstrings (for women).

While some of the higher-end calipers with displays can cost hundreds of dollars, you can also use simpler calipers that are much less expensive.

If you don't have a caliper, the next best option is to pinch the skin folds with your fingers, measure the thickness with a soft tape, and enter the numbers manually (that's where this calculator comes in).  

Also, a minimum of two measurements should be taken at each location. If the two measurements differ by more than 2 millimeters, a third measurement should be taken to determine their body fat, body composition, and fat category. The body composition calculator then uses the average of the 2-3 measurements when making the calculations.

Input Fields

US/Metric: Choose "English" (for US) or "Metric" units.

Gender: Select your gender.

Age: Your current age.

Weight: Your current scale weight.

Triceps: Use calipers to measure a vertical fold directly on the back of the upper arm and halfway between the shoulder and elbow.            

Thigh: Use calipers to measure a vertical fold directly on the front of the upper leg and halfway between the knee and the crease created when you lift your leg.            

Suprailiac: Use calipers to measure a diagonal fold directly above the hipbone. The angle of the fold should be about the same angle as the hipbone.            

Output Fields

Body Fat: The approximate percentage of your body’s mass that is made up of fat.

Fat Mass: The portion of your weight that is fat.

Lean Mass: The portion of your weight that is lean (not fat).

Body Fat Category: Your body fat category depends on your gender and your body fat percentage.

Body Fat Categories Table: This table shows you the Body Fat Range for each Classification so you can see how close your calculated Body Fat percentage is to the next Body Fat Classification range.

Jackson and Pollock 3 site formula

The skinfold measurements obtained with the calipers need to be input in the gender specific formulas and the intermediary result is the body density, noted D.

For females:

D = (1.0994921 - (0.0009929 x (Triceps + Thigh + Suprailiac)) + (0.0000023 x (Triceps + Thigh + Suprailiac)2) - (0.0001392 x Age))

For males:

D = (1.10938 - (0.0008267 x (Thigh + Chest + Abdomen)) + (0.0000016 x (Thigh + Chest + Abdomen)2) - (0.000257 x Age))

Body density is transformed in fat percentage with the SIRI formula:

BF% = 495/ D - 450

Body fat is obtained from the BF% and subject weight based on:

Body fat mass = BF% x Weight / 100

Lean body mass = Weight – Body fat mass

Example calculation

Taking the case of a female aged 28, weighing 146 lbs and having the following skinfold measurements:

Thigh = 24; Triceps = 18; Suprailiac = 26;

The calculation result is:
Body fat percentage = 26.6%;
Body fat mass = 38.8 lbs;
Lean body mass = 107.2 lbs;
Body density = 1.04 x 103 kg/m3.

Because fat percentages can offer information on the fitness levels of the body, the American Council on Exercise devised the following:

Status Females (% BF) Males (% BF)
Essential fat 10 to 13 2 to 5
Athletic build 14 to 20 6 to 13
Fitness 21 to 24 14 to 17
Above but acceptable 25 to 31 18 to 25
Obese 32 + 26 +

References

  1. Jackson AS, Pollock ML, Ward A. (1980) Generalized equations for predicting body density of women. Med Sci Sports Exerc; 12(3):175-81.
  2. Jackson AS, Pollock ML. (1978) Generalized equations for predicting body density of men. Br J Nutr; 40(3):497-504.
  3. Vasudev S, Mohan A, Mohan D, Farooq S, Raj D, Mohan V. (2004) Validation of body fat measurement by skinfolds and two bioelectric impedance methods with DEXA--the Chennai Urban Rural Epidemiology Study [CURES-3]. J Assoc Physicians India; 52:877-81.
  4. Aristizábal JC, Restrepo MT, Amalia L. (2008) Validation by hydrodensitometry of skinfold thickness equations used for female body composition assessment. Biomedica; 28(3):404-13.

Importend Notes and Disclaimer

 

Caveats and Recommendations: This calculator is NOT intended to diagnose illness or be used as a substitute for medical advice or treatment. Some models provide predictive outcomes which may not be accurate. Please consult a medical professional for any medical treatment or diagnosis advice.

 

Note: This calculator is presented for your own personal use and is to be used as a guide only. Medical and other decisions should NOT be based on the results of this calculator. Although this calculator has been tested, we cannot guarantee the accuracy of its calculations or results.

 

Disclaimer: This calculator is provided without warranty and CANNOT be used to diagnose or treat any disease or condition.

In 51 U.S. states are published

6004 Companies
1130 Counties
2188 Cities

The 5 newest Companies

Robert Bakke Jr

650 E Hospitality Ln, San Bernardino, CA 92408

John J Resich Jr Corporation: Resich Jr John J

840 W 9th St, San Pedro, CA 90731

Law Office Of Christopher J. Bernard

513 Weeping Willow Ln, Maineville, OH 45039

Flinn & Beagan LLC

8300 Boone Blvd # 225, Vienna, VA 22182

Morrison & Frampton Pllp: Purdy Ryan D

341 Central Ave # B, Whitefish, MT 59937

Other Companies

Ziegler Larry J

270 W Main St, Cedaredge, CO 81413

Peterson H Jeffrey

415 1st St S, Virginia, MN 55792

Polack Alan F

45684 Village Blvd, Shelby Township, MI 48315

Shirwo Darold M

9300 Wilshire Blvd, Beverly Hills, CA 90212

Thompson & Howle: Vaughn Carol S

601 Union St Suite 3232, Seattle, WA 98101